► Interactive Switch
► Where Used
Wire Harness Connector
6 pin connector.
Open Button
Push and hold the open button on a 4300 model.
Tap the open button to retract the sunroof on a 5300 model.
Close Button
Press and hold the close button on a 4300. Tap the close button on a 5300.
> Main
Rocker Solaire
Controller Information
Switch Installation Options
General Information
General
This switch is only used with Solaire 4300/5300 model sunroofs.
Operation
Operation
4300 Models:
Push and hold to operate the car icon opens the sunroof while the textured side closes the sunroof.
5300 Models:
Soft touch technology tap the car icon to open the sunroof. Tap the the textured side to close the sunroof.
Re-Teach Sequence
Re-Teach
C Version S.C.U. only
For an existing drive assembly
1. Use the “open” button to fully open the sunroof
2. Press and hold the “open” button for approximately ten (10) seconds until the sunroof moves past the full open / current position. (Refer to figure 1 for further explanation)
3. Quickly release the button; re-press and continue to hold it while the sunroof moves from the full open position past the full tilt and back to closed position. (This movement will begin approximately three (3) seconds after the button is held).
4. Release the button and verify programming success by pressing one touch open, close and tilt positions. If the three above functions work properly, the “Re-teach” procedure was successful.
Console
Headliner
Relocatable Switch Bracket
Webasto Thermo & Comfort North America, Inc.