► Interactive Switch
► Where Used
Wire Harness Connector
6-Pin Connector
Open Button
Press and hold to open the sunroof from a closed position.
Close Button
Press and hold this button to close the sunroof.
Vent Button
From a close position press and hold and the glass will tilt up to a vent position.
> Main
700 - II Entry Series
Controller Information
Switch Installation Options
Operation
Operation
By continuously pressing the button the glass panel will move in the OPEN direction. The movement of the panel continues as long as the button is pressed. The panel stops when the
button is released or the FULL SLIDE OPEN position is reached.
By continuously pressing the button the glass panel will move in the TILT direction. The movement of the panel continues as long as the button is pressed. The panel stops when the button is released or the FULL TILT position is reached.
By continuously pressing the button the glass panel will move towards CLOSE position. The movement of the panel continues as long as the button is pressed. The panel stops when the button is released or the FULL CLOSE position is reached.
Initialization Procedure
Initialization
• Start the initialization procedure with the glass panel in full closed position.
• Turn the ignition key to the “RUN” position (ideally a running vehicle engine to obtain maximum battery voltage)
• Press button (close) continuously. After approx. 10 sec. the glass panel will
○ move towards the FULL TILT position
○ move towards FULL CLOSED position.
• Release button (close). The sunroof system is now initialized.
• If the initialization is not successful, check if the sunroof installation is done correctly. Turn the ignition key to “OFF” and back to the “RUN” position and try again.
Reset Procedure
Reset
• Start the reset procedure with the glass panel in full closed position.
• Turn the ignition key to “OFF” for 30 seconds then back to the “RUN” position (ideally a running vehicle engine to obtain maximum battery voltage).
• Press button (close) continuously. After approx. 10 sec. the glass panel will
• move towards the FULL TILT position
• move towards FULL CLOSED position.
• Release button (close). Now the sunroof system has been reset.
Console
Headliner
Optional Switch Bracket
Webasto Thermo & Comfort North America, Inc.