► Interactive Switch
► Where Used
Adjustment Dial
This dial adjust the color of the LED backight.
1=Blue
2=Green
4=Red
7=White
Wire Harness Connector
6-Pin Connector
Open Button
In a close position tap this button to open the sunroof.
Close Button
Tap this button to close the sunroof from any position. In a teach mode you must hold this button continuously:
See below for the Initialization Procedure.
Vent Button
From a close position tap this button and the glass will tilt up to a vent position.
> Main
700 - II Comfort Series
Different Color Options
Controller Information
Switch Installation Options
General Information
General
The sunroof can be operated by a 3 button switch with self explanantory symbols. You can either tilt, slide or close the glass panel. The COMFORT switch is available in 3 colors (black, beige and gray), has LED illumination and a metal colored edge.
Operation
Operation
Ensure that your vehicle ignition is switched ON.
By pressing the button briefly the glass panel will move automatically towards the FULL SLIDE OPEN position. The panel stops when any of the buttons are pressed or when the FULL SLIDE OPEN position is reached.
By pressing the button briefly the glass
panel will move automatically towards FULL TILT position. The panel stops when any of the buttons are pressed or when the FULL TILT position is reached.
By continuously pressing the button the glass panel will move in the TILT direction in 4 steps. The 4 step function allows the user to find the most comfortable tilt position easily. The movement of the panel continues as long as the button is pressed.
The panel stops when the button is released or the FULL TILT position is reached.
By continuously pressing the button the glass panel will move towards CLOSE position. The movement of the panel continues as long as the button is pressed. The panel stops when the button
is released or the FULL CLOSE position is reached.
Initialization Procedure
Initialization
•Start the initialization procedure with the glass panel in the full closed position.
•Confirm the vehicle is in PARK and start the engine to assure voltage is above 11 (volts) during initialization.
•Press button (close) continuously. After approx. 10 sec. the glass panel will:
○ move towards the FULL TILT position
○ stay in FULL TILT position for approx. 2 sec.
○ move towards FULL SLIDE OPEN position
○ move towards FULL CLOSED position
○ move towards FULL SLIDE OPEN position
○ move towards the FULL TILT position
○ move towards FULL CLOSED position.
• Release button (close). The sunroof system is now initialized.
• If the initialization is not successful, check if the sunroof installation is done correctly. Turn the ignition key to “OFF” and back to the “RUN” position and try again.
Reset Procedure
Reset
• Start the reset procedure with the glass panel in full closed position.
• Turn the ignition key to “OFF” for 30 seconds then back to the “RUN” position (ideally a running vehicle engine to obtain maximum battery voltage).
• Within one minute press button (close) continuously. After approx. 10 sec. the glass panel will
○ move towards the FULL TILT position
○ stay in FULL TILT position for approx. 2 sec.
○ move towards FULL SLIDE OPEN position
○ move towards FULL CLOSED position
○ move towards FULL SLIDE OPEN position
○ move towards the FULL TILT position
○ move towards FULL CLOSED position.
• Release button (close). The sunroof system has now been reset.
Console
Headliner
Optional Switch Bracket
Webasto Thermo & Comfort North America, Inc.