► Interactive Switch
► Where Used
Ribbon Cable Connector
8-pin ribbon cable connector.
1 Button
User programmable move the panel to a select position. Press and hold the button for 6 seconds. The S.C.U will beep to notify you that the position has been set.
2 Button
User programmable move the panel to a select position. Press and hold the button for 6 seconds. The S.C.U will beep to notify you that the position has been set.
Close Button
This is pre-programmed to close the sunroof in any position.
Open Arrow
This is preprogrammed to open the sunroof from a closed position. Or to close the sunroof from a vent position.
Close Arrow
This is preprogrammed to close the sunroof from an open position. Or to vent the sunroof from a closed position.
> Main
5 Button Square
Controller Information
Switch Installation Options
Console
Headliner
Relocatable Switch Bracket
-
General Information
General
5 button interface, user programmable that is green LED back lit.
-
Operation
Operation
This switch uses Soft-Touch technology by tapping any of the buttons the sunroof will open to the select position. It also features auto close when the ignition is turned off the roof will automatically close. Just tap any of the buttons to override auto close.
-
Reprogram Sequence
Reprogram Sequence
Open the sunroof to the full open position using the left arrow
. Release the left arrow when the glass is in the full open position.Initiate Electronic Reprogramming sequence:
Press and hold the left arrow
for 10 seconds. The glass panel should jump back a 1/8" of an inch making an audible click sound. Release the left arrow .Press and hold the right arrow
until the glass panel reaches a full closed position. The S.C.U should recognize the 2 timing points "Full Open" and "Full Close". The Reprogramming sequence is complete.
Webasto Thermo & Comfort North America, Inc.