Operation 

 

By quickly pressing the switch the sunroof will

open  or  close immediately. Movement of the panels can be stopped by quickly pressing the switch again. By quickly pushing the single  or double vent button, the glass panels will move immediately into the corresponding positions.

 

By quickly pushing the close button , regardless of the panels position, the panels will close immediately.

 

When turning off your vehicles ignition, you will hear a beep sound to remind you that the auto-close will be activated. After three seconds the sunroof will close automatically and will let you know by beeping once.

Should you require the sunroof to stop, while closing, quickly press the switch  or . You can also prevent the panels from closing by pressing the switch  or  during the three second interval. When you switch the ignition on, the sunroof opens and closes in the normal manner.

 

PROGRAMMING THE COMFORT POSITION:

1. Place the panels in the desired position using button  or .

2. Push the comfort button  and hold the button for about 6 seconds until you hear a beep. On opening the sunroof with comfort button  the panels will stop in the preset position.

 

Program 

NOTE:

During teach cycle Anti-Pinch protection doesn’t work yet and interruption is not possible.

Therefore, make sure that glass panels can move freely and no limbs or objects will be jammed between glass panel and roof.

 

 

•Switch ignition on vehicle to “ON” Position

•Withing 60 seconds of applying power. Press all 4 buttons , ,  and  for at least 6 seconds. When you hear 10 beeps stop pressing buttons.

•Now, close sunroof by pressing button  (close) continuously.

•After a short beep, stop pressing button. Sunroof will run through teach cycle automatically (2 times fully open and close).

•When teach cycle is not executed well, sunroof will produce sound signal. Repeat steps 1 through 4.

•If teach cycle is not successful after several attempts, check if installation is done correctly: roof ring, trim profile, etc.